Mark-10 WT3-201M Wire Crimp Pull Tester (200 x 0.1 lbF | 3200 x 2 ozF)

Force Capacity: 200 x 0.1 lbF | 3200 x 2 ozF | 100 x 0.05 kgF | 1,000 x 0.5 N | 1 x 0.0005 kN

Accuracy: ±0.2% of full scale

Wire dia. range: AWG30 - AWG 3 [0.01 - 0.25 in (0.3 - 6.3 mm)]

Sample length range: Minimum 6.5 in [165 mm], excluding termination

Max elongation: 1.7 in [43 mm]

Speed range: Test speed: 0.4 - 12.0 in/min [10 - 300 mm/min]

Approach/reverse speed: 13.0 - 96.0 in/min [325 - 2,400 mm/min]

Speed setting accuracy: ±0.2%

Speed variation with load: ±0% [Stepper motor driven]

Power:

AC adapter: 100-240VAC, 50-60 Hz, 0.3 A

Battery: Rechargeable 8.4V NiMH

Low battery indicator appears when battery level is low, and gauge powers off automatically when power reaches critical stage.

Sampling Rate: 7000 Hz

Outputs:

USB / RS-232: Configurable up to 115,200 baud.

Mitutoyo: Serial BCD suitable for all Mitutoyo SPC-compatible devices. Analog: ±1 VDC at capacity, ±2% of full scale

General purpose: Three open drain outputs, one input

Set points: Three open drain lines

Safe overload: 150% of full scale (display shows “OVER” at 110% and above)

Weight: 26.5 lb [12.0 kg]

Environmental requirements: 40 - 100°F, max. 96% humidity, non-condensating

Datasheet